Howto configure the Linux kernel / drivers / mtd / onenand
- linux/drivers/mtd/onenand]]
OneNAND Flash Device Drivers[]
- depends on MTD != n
- Option: MTD_ONENAND
- Kernel Versions: 2.6.15.6 ...
- (on/off/module) OneNAND Device Support
- depends on MTD
- This enables support for accessing all type of OneNAND flash devices. For further information see <http://www.samsung.com/Products/Semiconductor/Flash/OneNAND_TM/index.htm>.
- Option: MTD_ONENAND_VERIFY_WRITE
- Kernel Versions: 2.6.15.6 ...
- (on/off) Verify OneNAND page writes
- depends on MTD_ONENAND
- This adds an extra check when data is written to the flash. The OneNAND flash device internally checks only bits transitioning from 1 to 0. There is a rare possibility that even though the device thinks the write was successful, a bit could have been flipped accidentally due to device wear or something else.
- Option: MTD_ONENAND_GENERIC
- Kernel Versions: 2.6.15.6 ...
- (on/off/module) OneNAND Flash device via platform device driver
- depends on MTD_ONENAND && ARM
- Support for OneNAND flash via platform device driver.
- Option: MTD_ONENAND_SYNC_READ
- Kernel Versions: 2.6.15.6 ...
- (on/off) OneNAND Sync. Burst Read Support
- depends on ARCH_OMAP
- This enables support for Sync. Burst Read.
Linux Kernel Configuration