Howto configure the Linux kernel / drivers / net / arm
- Acorn Network device configuration
- These are for Acorn's Expansion card network interfaces
- Option: ARM_AM79C961A
- Kernel Versions: 2.6.15.6 ...
- (on/off) ARM EBSA110 AM79C961A support
- depends on NET_ETHERNET && ARM && ARCH_EBSA110
- select CRC32
- If you wish to compile a kernel for the EBSA-110, then you should always answer Y to this.
- Option: ARM_ETHER1
- Kernel Versions: 2.6.15.6 ...
- (on/off/module) Acorn Ether1 support
- depends on NET_ETHERNET && ARM && ARCH_ACORN
- If you have an Acorn system with one of these (AKA25) network cards, you should say Y to this option if you wish to use it with Linux.
- Option: ARM_ETHER3
- Kernel Versions: 2.6.15.6 ...
- (on/off/module) Acorn/ANT Ether3 support
- depends on NET_ETHERNET && ARM && ARCH_ACORN
- If you have an Acorn system with one of these network cards, you should say Y to this option if you wish to use it with Linux.
- Option: ARM_ETHERH
- Kernel Versions: 2.6.15.6 ...
- (on/off/module) I-cubed EtherH/ANT EtherM support
- depends on NET_ETHERNET && ARM && ARCH_ACORN
- select CRC32
- If you have an Acorn system with one of these network cards, you should say Y to this option if you wish to use it with Linux.
- Option: ARM_ETHER00
- Kernel Versions: 2.6.15.6 ...
- (on/off/module) Altera Ether00 support
- depends on NET_ETHERNET && ARM && ARCH_CAMELOT
- This is the driver for Altera's ether00 ethernet mac IP core. Say Y here if you want to build support for this into the kernel. It is also available as a module (say M here) that can be inserted/ removed from the kernel at the same time as the PLD is configured. If this driver is running on an epxa10 development board then it will generate a suitable hw address based on the board serial number (MTD support is required for this). Otherwise you will need to set a suitable hw address using ifconfig.
Linux Kernel Configuration