Fandom

How To Wiki

How to configure the Linux kernel/drivers/net/arm

< How to configure the Linux kernel | drivers | net

1,795pages on
this wiki
Add New Page
Talk0 Share

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.

Howto configure the Linux kernel / drivers / net / arm


Acorn Network device configuration
These are for Acorn's Expansion card network interfaces


  • Option: ARM_AM79C961A
    • Kernel Versions: 2.6.15.6 ...
    • (on/off) ARM EBSA110 AM79C961A support
    • depends on NET_ETHERNET && ARM && ARCH_EBSA110
    • select CRC32
      If you wish to compile a kernel for the EBSA-110, then you should always answer Y to this.


  • Option: ARM_ETHER1
    • Kernel Versions: 2.6.15.6 ...
    • (on/off/module) Acorn Ether1 support
    • depends on NET_ETHERNET && ARM && ARCH_ACORN
      If you have an Acorn system with one of these (AKA25) network cards, you should say Y to this option if you wish to use it with Linux.


  • Option: ARM_ETHER3
    • Kernel Versions: 2.6.15.6 ...
    • (on/off/module) Acorn/ANT Ether3 support
    • depends on NET_ETHERNET && ARM && ARCH_ACORN
      If you have an Acorn system with one of these network cards, you should say Y to this option if you wish to use it with Linux.


  • Option: ARM_ETHERH
    • Kernel Versions: 2.6.15.6 ...
    • (on/off/module) I-cubed EtherH/ANT EtherM support
    • depends on NET_ETHERNET && ARM && ARCH_ACORN
    • select CRC32
      If you have an Acorn system with one of these network cards, you should say Y to this option if you wish to use it with Linux.


  • Option: ARM_ETHER00
    • Kernel Versions: 2.6.15.6 ...
    • (on/off/module) Altera Ether00 support
    • depends on NET_ETHERNET && ARM && ARCH_CAMELOT
      This is the driver for Altera's ether00 ethernet mac IP core. Say Y here if you want to build support for this into the kernel. It is also available as a module (say M here) that can be inserted/ removed from the kernel at the same time as the PLD is configured. If this driver is running on an epxa10 development board then it will generate a suitable hw address based on the board serial number (MTD support is required for this). Otherwise you will need to set a suitable hw address using ifconfig.


Linux Kernel Configuration

Also on Fandom

Random Wiki